Replacing The Battery - Atlantis Onepower 700 Mode D'emploi

1.8 Replacing the Battery

The Following Precautions Should be Observed When Working on Batteries:
Remove watches, rings, or other metal objects.

Use tools with insulated handles.

Wear rubber gloves and boots.

Do not lay tools or metal parts on top of batteries.

Disconnect charging source prior to connecting or disconnecting battery

terminals.
Before beginning the replacing of the battery You have to switch-off all the device
and detach AC cable from the wall receptacle.
Use a cross-type screwdriver to remove the 4 rear cover screws and slide back

the cover.
Gently Pull the battery out of the UPS.

Loosen the black wire from the negative (-, STEP4) terminal and red wire from

the positive (+) terminal.
Connect the battery leads to the new battery (small sparks at the battery

connectors are normal during connection).
Slide the battery into the UPS.

Close the rear cover and fasten 4 screws.

Dispose of the old battery properly at an appropriate recycling facility

Once the battery is disconnected, the loads are not
protected from power outages.
Dispose of the old battery properly at an appropriate
recycling facility.
27
ENG