Replacing The Battery - Atlantis ONEPOWER 1000 Manuel Utilisateur

Number Explanations
1
AC cable.
2
ICS.
3 Backup Outlets:
 3 Schuko (Surge)
 3 Schuko (Surge & Backup) for critical load.

1.9 Replacing the Battery

The Following Precautions Should be Observed When Working on Batteries:
 Remove watches, rings, or other metal objects.
 Use tools with insulated handles.
 Wear rubber gloves and boots.
 Do not lay tools or metal parts on top of batteries.
 Disconnect charging source prior to connecting or disconnecting battery terminals.
Before beginning the replacing of the battery You have to switch-off all the device
and detach AC cable from the wall receptacle.
 Use a cross-type screwdriver to remove the two top cover screws and slide back
the cover.
 Gently Pull the battery out of the UPS.
 Loosen the black wire from the negative terminal and red wire from the positive
terminal.
 Connect the battery leads to the new battery (small sparks at the battery
connectors are normal during connection).
 Slide the battery into the UPS.
 Close the top cover and fasten two screws then front panel and fasten two screws.
 Dispose of the old battery properly at an appropriate recycling facility.
Once the battery is disconnected, the loads are not
protected from power outages.
Dispose of the old battery properly at an appropriate
recycling facility.
Do not dispose of batteries in a fire. The battery may
explode. Do not open or mutilate the battery or batteries.
Released electrolyte is harmful to the skin and eyes.
When replacing the batteries, use the same number and
type of batteries. Internal battery voltage is 12Vdc.
Sealed, lead-acid, 6-cell battery.
22
ENG