Replacing The Battery - Atlantis ONEPOWER A03-PE602 Manuel De L'utilisateur

1.9 Replacing the Battery

The Following Precautions Should be Observed When Working on Batteries:
 Remove watches, rings, or other metal objects.
 Use tools with insulated handles.
 Wear rubber gloves and boots.
 Do not lay tools or metal parts on top of batteries.
 Disconnect charging source prior to connecting or disconnecting battery terminals.
Before beginning the replacing of the battery You have to switch-off all the device
and detach AC cable from the wall receptacle.
 Use a cross-type screwdriver to remove screws and slide back the cover.
 Gently Pull the battery out of the UPS.
 Loosen the black wire from the negative (-, STEP4) terminal and red wire from the
positive (+) terminal.
 Connect the battery leads to the new battery (small sparks at the battery
connectors are normal during connection).
 Slide the battery into the UPS.
 Close the rear cover and fasten the screws.
 Dispose of the old battery properly at an appropriate recycling facility
Once the battery is disconnected, the loads are not
protected from power outages.
Dispose of the old battery properly at an appropriate
recycling facility.
32
FRA