Front Panel Explanations; Rear Panel Explanations - Atlantis ONEPOWER 1000 Manuel Utilisateur

1.7 Front Panel Explanations

On the front panel You can found 1 LED for an easy diagnostic.
LED
Main Switch [
Acoustic Alarm

1.8 Rear Panel Explanations

Information
] Press the UPS On/OFF [
seconds, then the Buzzer sounds twice/3 times, the UPS
will be start-up/Switch OFF. The power on indicator light
will illuminate (blue).
To enable "DC-Start" Function when Utility fails. (To enable
DC Start properly, you are recommended to connect <80%
output load with the UPS only). P.S. Make sure the
computer connected to the UPS is switched on before
enable the "DC-Start" function. You are not recommended
to add some other computer or peripherals after DC-Start
function is activated.
Battery Mode (buzzer alarms every 30 seconds).
UPS is in battery low condition (buzzer alarms every 2
seconds).
OverLoad (buzzer alarms twice in a second).
Fault (buzzer alarms continuously).
] Switch for approx. 2/3
21
ENG