Connect The Loads - Atlantis ONEPOWER 1000 Manuel Utilisateur

1.5 Connect the loads

First, plug the loads into the output connectors on the rear of the UPS then connect
the UPS with the AC Mains. To use the UPS as a master "On/Off" switch, make sure
that all of the loads are switch "On".
Do not connect a laser printer to the outlets. These UPS
outlets provide battery power and surge protection to the
equipment when utility voltage is outside acceptable
limits.
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 10 hours
before initial use. The unit charges its battery while
connecting to the utility.
19
ENG