Connect The Loads; Connect Telephone / Network Surge Protection And Usb - Atlantis OnePower 841 Manuel Utilisateur

1.5 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS. To use the UPS as a master "On/Off" switch,
make sure that all of the loads are switch "On".
Caution: Do not connect a laser printer to the outlets. These UPS outlets provide
battery power and surge protection to the equipment when utility voltage is
outside acceptable limits.

1.6 Connect telephone / Network Surge protection and USB

Connect a single line telephone or a 10 base-T / 100 base-T network cable into the
RJ-45 / RJ-11 telephone / network surge protection "IN" jack on the back of the
UPS. Connect from the "OUT" jack with telephone cable (supplied) or network
cabling (not supplied) to a fax modem or network port.
Connect the supplied interface cable to the USB computer interface port on the
back of the UPS. Connect to the computer. See software document for installation
instruction.
26