Connect The Loads - Atlantis HostPower 1102 Mode D'emploi

20cm

1.5 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS. To use the UPS as a master "On/Off" switch,
make sure that all of the loads are switch "On".
20cm
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 6 hours
before initial use. The unit charges its battery while
connecting to the utility.
NEVER connect a laser printer or scanner to the UPS unit.
This may cause the damage of the unit. These UPS outlets
provide battery power and surge protection to the
equipment when utility voltage is outside acceptable limits.
27