Appendix A: Trouble Shooting & Support; A.1.1 Ups; A.1.2 Viewpower - Atlantis HostPower 1102 Mode D'emploi

APPENDIX A: TROUBLE SHOOTING & SUPPORT
If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and effort
but if the problem persist, then consult your service provider.

A.1.1 UPS

The LED and the acoustic signals are a profit tool to individualize immediately
possible problems
Situation
Mains normal but Line
(AC MODE) LED is not
on.
Alarm buzzer
continuously
Utility is normal.
No LEDs display on the
front panel
UPS does not provide
expected backup time.
Do this device support
the AutoRestart
function?

A.1.2 ViewPower

Situation
How to install the
Check Items
1. Is the power switch on?
2. Check the Fuse/ICS?
3. Is the power cord loose?
beeps 1. Check the load status
when
1. The UPS's battery is weak
due to recent outage.
2. The UPS's battery is near
the end of its service life.
Yes. When battery run out of time, the UPS will be shut
down. But when AC recovery, the UPS will be auto
restart and charge the battery.
Once started the UPS you can connect it to PC through USB
Solution
32
Solution
1. Press Main Switch on.
2. Change fuse with same
rating. Check ICS.
3. Re-connect the power
cord properly.
1. Remove
uncritical load.
2. Remove
uncritical load and re-
switch on the UPS.
1. Recharge the UPS for
24 hours.
2. Contact Atlantis.
1. Charge the battery.
2. If the battery is near
the end of its service
life, you have
replace the battery.
some
some
to