Appendix A: Trouble Shooting & Support; A.1.1 Ups - Atlantis Host Power 1001 Mode D'emploi

APPENDIX A: TROUBLE SHOOTING & SUPPORT
If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and effort
but if the problem persist, then consult your service provider.

A.1.1 UPS

The LED and the acoustic signals are a profit tool to individualize immediately
possible problems
Situation
Mains normal but Line
(1) LED is not on.
No LEDs display on the
front panel
UPS is switched off
The UPS
normally, but
UPS does not provide
expected backup time.
The UPS
1. Is the power switch on?
2. Check the Fuse?
3. Is the power cord loose?
1. Battery voltage is too low 1. Recharge the UPS for
operates 1. Check the load status
is lit.
1. The UPS's battery is weak
due to recent outage.
2. The UPS's battery is near
the end of its service life.
operates 1. Building wiring error such 1. Call
Check Items
41
Solution
1. Press Main Switch on.
2. Change fuse with same
rating.
3. Re-connect the power
cord properly.
24 hours.
2. Contact Atlantis.
1. UPS will not
restart if it has been
turned off by switch or
shutdown due
overload or
circuit
1. Remove
uncritical load.
2. Remove
uncritical load and re-
switch on the UPS.
1. Charge the battery.
2. If the battery is near
the end of its service
life, you have
replace the battery.
a
auto-
to
short-
some
some
to
qualified