Dip Switch; Ups Start Up - Atlantis Host Power 1001 Mode D'emploi

7
8
9

DIP SWITCH

The voltage & frequency of the UPS might be re-set by the DIP Switch on the rear
panel of the UPS. The following charts may bring you clear pictures about how the
settings are done by the DIP Switch.

1.9 UPS Start Up

Connect the UPS to the wall receptacle and wait approximately 5-6 seconds,

Amber LED should flash to indicate charging.
Push the "On" Switch on the front panel of the UPS until Buzzer sounds, then

release.
The LCD Display lights up along with an LED. If Utility is normal, the UPS will

run under Utility mode (Green LED). On the contrary, the UPS will run under
Backup mode (Solid Amber LED) and the buzzer alarms every 2 seconds in
case of blackout or over/under voltage.
Sticker with details on the product.
AC Fuse Holder. (10A/230Vac on A03-HP1001), (12A/230Vac)
AC Inlet
The UPS "On" will not be executed if the above procedure is
not done completely, which means the buzzer has commenced
to sound.
The UPS will remain at "NO" output, if the start-up operation is
not proceeded properly even though the Input Power Cord is
connected to the wall receptacle.
35