Operation Test - Atlantis Host Power 1001 Mode D'emploi

1.10 Operation Test

Turn Off the UPS

Push the "Off" Switch for at least 3 seconds to turn off the UPS. If you press
the "Off" Switch less than 3 seconds, the UPS will not execute shutdown
command
In some occasions, the UPS will shut itself down in case of overload, output
short-circuited or battery cutoff point reached in the Backup mode.
The UPS will automatically shut off the output and beep for 5 seconds then
completely shut itself down.
Plug-in Charge

If the Input Power Cord is connected to the wall receptacle properly and the
utility is normal, the UPS will start to charge automatically without processing
"Turn On" procedure. This is indicated by a flashing amber LED. You have to
charge for at least 8 hours every 3 months to prevent the battery from over-
discharge when the UPS is in an idle condition.
Auto-Restart

The UPS will automatically restart to provide power to the output if the utility
recovers after battery end cutoff or UPS shutdown message provided by
software. On the contrary, the UPS will not auto-restart if it has been turned
off by switch or shutdown due to overload or short-circuit. You are required
to start up the UPS manually. If you don't need UPS auto-restart, you can
turn off the UPS by proceeding the "Turn Off" procedure.
Alarm Silence

The Alarm might be turned off by pushing the "On" Switch for approximately
1 second in the "Backup" mode. Unless any other warning or fault condition
occurs, the alarm remains at Silence condition once the "Alarm Silence" is
turned off.
IMPORTANT NOTICE:
Plug the UPS into the wall receptacle to charge the UPS for
over 8/10 hours after initial installation.
STORAGE:
 Store at -15 to +30 °C (+5 to +86 °F), charge the
UPS battery every 4 months.
 Store at +30 to +45 °C (+86 to +113 °F), charge
the UPS battery every month.
due to insufficient
36
pressing time.