Appendix A: Trouble Shooting & Support; A.1.1 Ups - Atlantis OnePower 800X Manuel Utilisateur

APPENDIX A: TROUBLE SHOOTING & SUPPORT
If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and effort
but if the problem persist, then consult your service provider.

A.1.1 UPS

The LED and the acoustic signals are a profit tool to individualize immediately
possible problems
Situation
No LED display on the
front panel.
Alarm continuously
sounds (every
seconds) when
mains is normal.
Alarm
continuously when the
mains is normal.
When power fails, back-
up time is shorten.
Check Items
1. Low battery.
2. Battery fault.
3. The UPS is not turned on.
1. The UPS is overload.
1/2 2. UPS is fault
the
sounds 1. Battery defect.
2. Charging
damaged
1. The UPS is close to
overload.
2. Battery voltage is too low.
3. Battery defect. It might be
due to high temperature
operation environment, or
improper operation to
board is
33
Solution
1. Charge the
least 8 hours.
2. Replace the
with the same type of
battery.
3. Press the power switch
again to turn on the
UPS.
1. Remove
uncritical load.
2. Remove
uncritical load and re-
switch on the UPS.
3. Contact Atlantis.
1. Replace the
with the same type of
battery.
2. Contact Atlantis.
1. Remove some critical
load.
2. Charge the
least 8 hours.
3. Replace the
with the same type of
battery.
UPS at
battery
some
some
battery
UPS at
battery