Connect The Loads; Connect Telephone Surge Protection And Usb - Atlantis HostPower 851 Manuel Utilisateur

20cm

1.5 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS. To use the UPS as a master "On/Off" switch,
make sure that all of the loads are switch "On".

1.6 Connect telephone surge protection and USB

Connect a single line telephone into the RJ-11 telephone surge protection "IN" jack
on the back of the UPS. Connect from the "OUT" jack with telephone cable to a fax
modem.
20cm
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 4 hours before
initial use. The unit charges its battery while connecting to the
utility.
4 hours
NEVER connect a laser printer or scanner to the UPS unit. This
may cause the damage of the unit. These UPS outlets provide
battery power and surge protection to the equipment when
utility voltage is outside acceptable limits.
25