SilverCrest SKMP 1300 D3 Mode D'emploi page 42

Seal 6 for blade assembly 7:
To clean, remove the seal 6 of the blade as-
sembly 7.
CAUTION:
When you put the blade assembly 7
back into the blender jug 5, the seal 6
of the blade assembly 7 must fit correct-
ly, otherwise the contents may leak.
40 GB
In order to insert the blade assembly 7, pro-
ceed as follows:
1. Turn the blender jug 5 upside down.
2. Place the blade assembly 7 carefully
into the blender jug 5.
3. Turn it anticlockwise at the two han-
dles 25 until it stops.
Note that the lower ridges 26 at the
base of the blade assembly 7 must en-
gage under the upper ridges 27 in the
blender jug 5. Check that it is secure.
25
25
26
27