General Information; Purpose Of The Machine; Safety Information; Detergent - Hedson GP 24 Manuel D'utilisation

ENGLISH
1.

GENERAL INFORMATION

This User Manual will provide important information
concerning the GP 24, and will describe how to use
the Wheel Washer safely. Read the entire User Manual
before using the unit. For safe use, it is important that
the unit is handled properly. It is important that you
follow the instructions carefully. Please refer carefully to
all pictures in the end of this document for a complete
understanding.
2.

PURPOSE OF THE MACHINE

This machine is designed for cleaning of vehicle wheels
i.e. the tyre and rim assembly. Any other area of use is
prohibited.
PLEASE NOTE: A flat tyre cannot be cleaned in the
machine as it will not rotate properly.
This high quality piece of equipment for professional
users increases the service level and the efficiency in the
workshop.
The wheel washer cleans the wheels with an
environmentally friendly cleaning method. Plastic beads
(shot medium) and water are blasted onto the rim with low
pressure, ensuring a gentle and thorough cleaning for all
kinds of rims. The dynamic flush pipe moves slowly over
the rim outside during the cleaning process and reaches
every spot on the rim, especially good for cleaning high
polished alloy rims, big tyres (SUV, transporters), and more
sophisticated rims.
The GP 24 Wheel Washer cleans the wheels in an
environmentally friendly way. The machine works with
a closed water system, and the water consumption per
washed wheel is very low, approximately 1 L/wheel. The
plastic beads and water clean the wheel thoroughly yet
gently and no detergents or chemicals are needed. GP
24 Wheel Washer can be used with an optional water
cleaning system.
3.

SAFETY INFORMATION

Hazards may arise from improper use of the GP 24. In
order to maintain the high safety standard of the unit, it is
important that these instructions are followed.
• Do not operate the unit until you have read and fully
understood this entire User Manual.
• The unit should be installed as described in the
instructions.
• The unit should be used as described in the
instructions.
• The unit should be maintained as described in the
instructions.
• Only original spare parts must be used.
• This User Manual must be available and in legible
condition in close proximity to the unit. Every user
should know where to find the User Manual.
4
GP 24
• Operating instructions should be formulated on the
basis of this User Manual for GP 24, and translated
into the language spoken by the employees.
• Do not modify or in any way alter the unit.
• Wear goggles or similar, to protect your eyes from
splashing water.
• It is absolute vital to sweep the floor regularly to avoid
risk for a slippery floor (see picture 11).
• When using equipment that handles warm water,
there is a risk of harmful bacterium emerging (water-
and/or airborne diffusion), especially if the water has
been left non-operative in the machine for a while. We
therefore recommend the following procedures:
• By adding a bactericide to the water in the
washing compartment (art.no. 230521, 2 litre per
300 litre water)
• To empty out the water of the machine when not
using it.
• Caution: Before removing the
MotorCompartmentCover (see picture 3), make
sure to disconnect the power supply and the airline
supplying compressed air (see picture 4) to the
machine.
• Caution: The MotorCompartmentCover (see picture
3) may only be removed by authorized personnel
due to exposure of moving parts and easy access to
electrical parts.
• This EU model may not be sold in North America.
4.

DETERGENT

There is a special detergent developed for this Wheel
Washer if required. Article number: BIO-291
PLEASE NOTE: Warranty is void if a non approved
detergent or chemical is used in the machine.
5.

SHOT MEDIUM

The DoublePower shot medium mixture of plastic beads
that is blasted onto the wheel to clean it is carefully
designed to give the best possible washing result
without damaging the rims. It has specially adapted
floating properties, degrees of hardness and wearing
qualities. The DoublePower shot medium can be
ordered using the number 230794 (bag containing
20kg). In an empty Wheel washer 20kg Shot medium is
needed.
PLEASE NOTE: Warranty is void if non approved plastic
beads are used in the machine.
6.

INSTALLATION

• First of all, check if the machine has been damaged
during the transport. If so, report this immediately to
the transport-company.
230754-EN rev.1 2016-10-18