Running-In; Alarm; Functions On The Control Panel - Hedson GP 24 Manuel D'utilisation

4. When the trolley stands in position and is pressed
towards the machine, the display show the picture
below, and the machine will automatically lower the
guide rail and lock the trolley to the machine, then the
trolley is moved one stop to the left.
If the trolley is placed too far to the left, picture below
will be shown on the display and the trolley must be
moved to the right.
If the trolley is placed too far to the right, picture
below will be shown on the display and the trolley
must be moved to the left.
5.
Start the machine (see chapter 11.3) by pressing one
of the operation buttons.
6. When the machine is washing a wheel from a trolley,
another trolley can be connected (maximum of 4
trolleys can be connected) to the first trolley. This
allows the machine to continue washing without
interruption. Please note that when the trolley is
moving no trolley may be connected.
7. When the last wheel on the trolley is washed and fed
out from the machine, the guide rail is lifted and the
trolley is disconnected from the machine. The display
will show the picture below and the trolley needs to
be removed from the machine.
Finally, always check that there are no shot medium left
on the rim before it is mounted onto the car.
8.

RUNNING-IN

When the machine is new, the inside surface of the
pump and pipes will be smoothened and fragments
of the shot medium will disengage. An extra change
of water and rinse of the machine after 100 washes is
therefore strongly recommended. The shot medium
should then also be rinsed with water while they are
collected in the basket.
6
GP 24
9.

ALARM

Three types of alarms can occur in the machine, A-, B- or
C-types.
Type A-alarm: The machine will stop immediately and
the error code and description will be shown on the
display. The error should be corrected before trying to
start again.
Type B-alarm: The machine will still be able to operate
but the specific function i.e. immersion heater will be
turned off.
Type C-alarm: The machine will stop immediately and
the error code and description will be shown on the
display. To correct a C-alarm the machine needs to be
turned OFF, otherwise the machine will not be able to
restart.
Example: If emergency stop is pressed this screen will
be shown with error code and a short description.
Pressing enter will show an instruction to turn off
machine and correct the error.
When the machine is turned on again STOP-button
needs to be pressed for 3-seconds to confirm that the
error is corrected.
For a list of all alarms see chapter 19.

10. FUNCTIONS ON THE CONTROL PANEL

4
5
1. LCD DISPLAY
2. SHOT MEDIUM COLLECTION
3. STOP
4. OPERATION BUTTONS
5. STD/SUV WHEELs
6. SETTINGS
7. LID CONTROLS
1
4
4 4
6 2
7 3
230754-EN rev.1 2016-10-18