User Interface - Hedson GP 24 Manuel D'utilisation

10.1 LCD DISPLAY
10.2 SHOT MEDIUM COLLECTION
The water should be changed every 300 wash cycle.
To do this, press the shot medium collection button to
collect the beads.
MACHINES WITHOUT WATER CLEANING: Press the
shot medium collection button. The machine will
automatically start collecting the shot medium. See
chapter 12 for instructions of changing the water.
MACHINES EQUIPPED WITH WATER CLEANING: If your
machine is equipped with the water cleaning kit, there
are two choices after the shot medium collection button
has been pressed.
You can now choose between shot medium collection
and water cleaning. The shot medium collection is pre-
defined.
By starting this, just press ENTER again. See chapter 12
for instructions of changing the water.
After the shot medium collection is finished, the water
cleaning icon will be pre-marked. Press ENTER to start
this session, or BACK or STOP to abort.
PLEASE NOTE: Always turn off the main switch before
emptying out the water in the machine!
10.3 STOP
STOP Aborts wash programs and takes the user to main
screen from settings. After a C-alarm STOP-button needs
to be pressed for 3 seconds to reset the machine.
10.4 OPERATION BUTTONS
Operation buttons for choosing Wash Programs, and
navigate in the Settings Menu.
10.5 STD/SUV WHEELS
The machine is default set at wheel dimensions up to
20". Washing wheels larger than 20", or SUV-wheels,
press the button. An icon showing that SUV-mode is
activated will now show up in the LCD.
In SUV-mode, the dynamic arm will make a larger
sweep to clean the bigger rim area. The SUV-mode
will automatically cancel after four wheels have been
washed.
If you wish to cancel the SUV-mode, just press the
button again. The STD/SUV icon up in the LCD will now
disappear and the machine is optimized for standard
wheels.
To keep the SUV mode, press the button during 4 sec.
230754-EN rev.1 2016-10-18
GP 24
10.6 SETTINGS
The Settings mode enables you to view and change
advanced system parameters. Thanks to our
sophisticated control system in this wheel washer many
settings can be altered. This is normally not a part of the
everyday use.
To enter settings, press the button on the user panel.
10.7 LID CONTROLS
These buttons opens or closes the lid.

11. USER INTERFACE

11.1 BASIC NAVIGATION
• The display shows four software defined options in
the bottom field.
• To adjust values, use the operation buttons. Usually
the furthest right is ENTER or NEXT, and the left is
BACK or CANCEL.
• You can always abort by pressing the STOP-button.
11.2 MAIN SCREEN
Water Door
change open
indicator
Time
Trolley in
Heater
place
active
SUV wheel
activated
Error
warning
Wash programs
7