Hedson GP 24 Manuel D'utilisation page 13

Error
code Text on display Action
C041 Cannot read Restart the machine.
NVM, restart
machine
A045 Cylinder 1 Check end position
not retracted sensor 1-.
A046 Cylinder 1 Check end position
not extended sensor 1+.
A047 Cylinder 2 Check end position
not retracted sensor 2-.
A048 Cylinder 2 Check end position
not extended sensor 2+.
A049 Cylinder 3 Check end position
not retracted sensor 3-.
A050 Cylinder 3 Check end position
not extended sensor 3+.
A051 Cylinder 4 Check end position
not retracted sensor 4-.
A052 Cylinder 4 Check end position
not extended sensor 4+.
A053 Cylinder 5 Check end position
not retracted sensor 5-.
A054 Cylinder 5 Check end position
not extended sensor 5+.
A055 Cylinder 6 Check end position
not retracted sensor 6-.
A056 Cylinder 6 Check end position
not extended sensor 6+.
A057 Emergency Reset emergency stop
stop activated and restart machine.
A060 Problem side CHeck that the side support
support can mov freely i.e no wheel
inside machine.
C061 Air pressure Check that compressed
low air is connected.
A062 Trolley out of Replace the trolley
position in start position.
C063 Terminal box Check that the cable to the
communication terminal box is not damaged.
loss
A064 Terminal box Check end position sensors
MF1 overload and pressure guard.
A065 Terminal box Check warning light,
MF2 overload buzzer and solenoids.
See chapter 11.5.9 Alarm Log
230754-EN rev.1 2016-10-18
GP 24
13