Illustrations; Preparing For Use - Miele Dynamic U1 Mode D'emploi

Illustrations

The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating instruc-
tions.

Preparing for use

Assembling the vacuum cleaner
(dia. 01)
 Raise the vacuum cleaner into the
vertical position.
 Insert the handle into the vacuum
cleaner until it clicks into position.
To activate the exhaust filter change
indicator
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
02).
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
If your vacuum cleaner is fitted with fil-
ter b or c, you need to activate the ex-
haust filter change indicator.
 Open the lid of the exhaust filter com-
partment and pull the exhaust filter a
little way out of the holder (dia. 03).
 Remove the label, then put the ex-
haust filter back in again (dia. 04).
 Press the exhaust filter change indic-
ator (dia. 05).
After approx. 10 - 15 seconds a thin red
stripe will appear in the left hand side of
the display (dia. 06).
 Close the exhaust filter compartment
lid.
Exhaust filter change indicator
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 oper-
ating hours, or approx. one year of av-
erage use, the display will be com-
pletely filled with red (dia. 07).
Use
Unwind the mains cable (dia. 08)
The lower cable hook swivels round.
 Turn it upwards so that the cable can
be removed easily.
Winding up the mains cable (dia. 09)
When the vacuum cleaner is not in use,
the cable can be wound around the two
cable hooks.
Secure the mains cable by clamping the
plug to the cable (see detail).
Mains cable whilst vacuuming
(dia. 10)
 Whilst vacuuming, the mains cable
can be fed through the guide at the
side of the upper cable hook.
This way the mains cable will not get in
the way during vacuuming. This also
protects the cable from becoming
kinked.
To release the vacuum cleaner
(dia. 11)
 Step on the foot release briefly and
tilt the vacuum cleaner to a comfort-
able position for vacuuming.
en
37