Illustrations; Preparing For Use - Miele Complete C2 1115 Mode D'emploi

en
Notes on Delegated Regulation
(EU) No. 665/2013 and
666/2013
This vacuum cleaner is a general pur‐
pose vacuum cleaner.
The adjustable floorhead supplied is
designed, when set to the carpet set‐
ting, for intensive vacuuming of carpets
as described in Delegated Regulation
(EU) No. 665/2013 and 666/2013.
The hard floorbrush, if supplied, is de‐
signed for intensive vacuuming of hard
floors with gaps and crevices as descri‐
bed in the above regulations. If this is
not supplied with your vacuum cleaner,
use the adjustable floorhead supplied in
the hard floor setting for intensive
cleaning of hard floors with gaps and
crevices as described in the above reg‐
ulations.

Illustrations

The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating instruc‐
tions.

Preparing for use

Attach the suction hose (dia. 01)
 Insert the hose connector into the
suction socket on the vacuum clea‐
ner until it clicks into position. To do
this, line up the guides on the two pi‐
eces.
To detach the suction hose (dia. 02)
 Press the release buttons at the side
of the hose connector, and lift the ho‐
se from the socket.
36
All manuals and user guides at all-guides.com
Connect the suction hose to the han‐
dle (dia. 03)
 Fit the connector at the other end of
Your vacuum cleaner is fitted with one
of the following tubes, depending on
model:
– EasyLock suction tube
– Telescopic suction tube
To assemble the EasyLock tube
(dia. 04)
 Hold the suction tube by the connec‐
 Slide the connection piece upwards
Connect the handle to the suction
tube (dia. 05)
 Insert the handle into the suction tu‐
To detach the handle
 To detach the handle from the sucti‐
To adjust the telescopic tube (dia. 06)
One part of the telescopic tube is
packed inside the other and can be ad‐
justed to suit your height for comforta‐
ble vacuum cleaning.
the suction hose into the handle until
it clicks into position.
tion piece and push it into the second
suction tube, turning it clockwise or
anti-clockwise until it clicks into posi‐
tion.
until it clicks into position.
be until it clicks into position. To do
this, line up the guides on the two pi‐
eces.
on tube, press the release button
and pull the handle out of the sucti‐
on tube, twisting it slightly as you do
so.