Miele Complete C2 1115 Mode D'emploi page 37

 Press the release button to release
the tubes and adjust to the required
height.
Attach the standard floorhead / hard
floorbrush (dia. 07)
 Push the suction tube into the floor‐
head / floorbrush and turn it clockwi‐
se or anti-clockwise until it clicks into
position.
 To detach the floorhead / floorbrush
from the suction tube, press the lo‐
cking button and pull the suction tu‐
be away from the floorhead.
Using the hard floorbrush
(depending on model)
Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
This hard floorbrush is especially suita‐
ble for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
To adjust the standard adjustable
floorhead (dia. 08, 09 + 10)
This vacuum cleaner can be used for
daily cleaning of carpets, rugs and ro‐
bust hard flooring.
Miele offer a range of other floorheads,
brushes and accessories for other
types of flooring and special require‐
ments (see "Optional accessories").
Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
Vacuum carpets and rugs with the
brush retracted:
All manuals and user guides at all-guides.com
 Press the  foot control.
Clean hard flooring which is not sus‐
ceptible to scratching, as well as floor‐
ing with gaps or deep crevices in it with
the brush protruding:
 Press the  foot control.
EcoTeQ floorhead (dia. 10)
To activate the exhaust filter change
indicator
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
11).
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
If your vacuum cleaner is fitted with fil‐
ter b, c or d, you need to activate the
exhaust filter change indicator.
 Lift the release catch for the dust
 Remove the indicator strip (dia. 13).
 Press the exhaust filter change indi‐
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 15).
If the suction power of the EcoTeQ
floorhead seems too high, reduce
the suction until the floorhead is eas‐
ier to manoeuvre (see "Use - To reg‐
ulate the suction power").
compartment lid and raise the lid as
far as it will go (dia. 12).
cator (dia. 14).
en
37