Armrests/Side Parts; Armrest Height; Seat Height; Seat Angle - B+B Pyrolino Mode D'emploi

Pyrolino
| Children's wheelchair

4.3. Armrests/side parts

The side parts are securely fixed on the armrests. To make it easier to
get into or out of the wheelchair, simply pull out the armrests with the
side parts upwards (Fig. 16).
16

4.3.1. Armrest height

You can adjust the armrest height. Do do this, the sliding block must
be pushed along the armrest rail. Loosen the Allen screw (Fig. 17) with
17
a size 4 mm Allen wrench. Move the armrest to the desired position
and tighten the Allen screw again. Repeat this procedure on the other
side. Please make sure that both armrests are always adjusted to the
same height.

4.4. Seat height

The seat height can be changed by simultaneously adjusting the
18 driving wheel and the front wheel (see item 4.6). In the process ensure
that the driving and front wheels are adjusted in the same direction
and by the same value.

4.5. Seat angle

If you incline the seat of the wheelchair backwards, this means you
will be seated more deeply and firmly in the chair. To lean the seat
backwards, you have to move the quick-release axles (see driving
19
wheels) to a higher position. If you want to incline the seat forwards,
fix the quick-release axle in a lower position. The reverse is true of the
front wheels. If you attach the front wheel lower in the fork, the seat
will be inclined backward. If you attach the front wheel higher in the
50
Do not use the side parts to carry the wheelchair!
Children's wheelchair |
fork, this results in a negative seat inclination towards the front.

4.6. Adjusting the wheels

4.6.1. Driving wheel height

Remove the driving wheel (Fig. 18) to make work easier. To adjust the
height of the driving wheel and therefore to raise or lower the entire
wheelchair, you must first remove the mounting of the driving wheels.
You can use an Allen wrench to loosen the fastening nuts (see Fig. 19)
on the axle mounting.
Now you can remove the mounting and attach it at the desired height.
Tighten the nut again and attach the driving wheel. Make sure that the
driving wheels are mounted at the same height.
When the driving wheel height is changed, the
locking brake must be readjusted.

4.6.2. Front wheel height

The front wheel height can be adjusted in three stages. Loosen the
Allen screw (see Fig. 20) and pull out the wheel axle. Attach the front
wheel at the desired height and tighten the screw again.
Make sure that the front wheels are mounted at the same height.
Bischoff & Bischoff GmbH | 01.06.2019
Pyrolino
20
21
90°
22
23
51