Side Parts/Sections; Height Adjustable Side Parts (Optional); Height Adjustment; Brakes - B+B S-Eco 2 Mode D'emploi

S-ECO 2
| Standard wheelchair
4.3. Side parts
Swinging the side parts
To make it easier to get on and off the wheelchair, both side parts with
the armrests can be swung backwards. Use the lock device lever (Fig.
12), press it gently with your finger and at the same time swing the
side part backwardly (Fig. 13).
Locking the side parts
12
To lock the side part, fold it forward and let it snap into the lock device
with a gentle push (Fig.
4.3.1. Height adjustable
side parts (optional)
It is possible to equip your S-Eco wheelchair with height adjustable
side parts. (only long version). The height adjustable side parts can be
13
pivoted and are secured by a hexagon socket screw (6 mm) secured
to avoid slipping out. The side part is removable and swivel-mounted.

Height adjustment

• Use the stop lever to adjust the armrest to the desired position.
• 75 mm, 5 steps at 15 mm - 190 - 265 mm
• Armrest upholstery depth-adjustable (desk / long)
• When you have reached the desired position just let off the lever.
14
The locking will snap in.
• The height adjustment was chosen correctly if the supported
forearm forms are in a right angle with the upper arm and forearm.
15
14).
Standard wheelchair |

4.4. Brakes

Using the parking brake
To use the brake just push the brake lever forward until it snaps (Fig.
15). To loosen the brake, pull the lever backwards (Fig. 16)
Adjustment of the parking brake
If you should notice any unusual braking behaviour you have to do the
following:
• First check the tyres for adequate air pressure. There should be a
pressure of 300- 400 k Pa (3-4 bars) (does not apply to tyres which
are puncture proof tires).
• Check the tread depth. Pay attention whether ther is even abrasion.
If the tread depth is > than 1 mm, the tyres must be replaced by a
qualified mobility dealer.
• Now check the adjustments of the brake. It must be adjusted in
the way that there is a distance between the running surface of
the wheel and the pivot bolt of 15 mm when brakes are open. The
pivot bolt must be horizontal e.g. parallel to the ground.
• After loosening both lens head screws with hexagon socket screws
(5 mm) at the brake mounting (Fig. 17) you can adjust the brakes
to the correct position.
Bischoff & Bischoff GmbH | 13.02.2020
S-ECO 2
15
16
17
16