Leg Rests; Horizontally Adjustable Leg Rests (Optional) - B+B S-Eco 2 Mode D'emploi

S-ECO 2
| Standard wheelchair

4.2. Leg rests

The S-Eco 2 is equipped with removable leg rests (Fig. 07).
Both leg supports are supplied with the foot plates attached. The
foot plates on both leg supports can be folded upwards in the sitting
position.
07
Assembling the leg rests
Hold the legrests on the upper part and bring it into the leg rest fixtures
so that they point outwards. Swing the leg rests forward until they lock
in place (Fig. 08).
08
Swinging the leg rests
To make it easy for you to get on and off the wheelchair you can fold
up the foot plates or swing the leg supports outside or inside without
removing them.
• Pull the button, in this way, the lock is opened (Fig. 09).
• Now you can swing the leg rest outwardly or inwardly (Fig. 10).
09 • If necessary, fold the foot plate upward beforehand.
To get back to the original state just swing the leg rests frontally until
they snap in.
10
13
Before you start driving your wheelchair make
sure that the leg rests are firmly fixed.
Standard wheelchair |
When you get off your wheelchair make sure you
NEVER step on the foot plate under no circumstances!
Adjustment of the leg rest length
The length of the leg rest can be adjusted up to 12 mm. To do this you
have to undo the socket-head cap screw (hexagon socket 5 mm) and
adjust the leg rest according to your choice (Fig. 11).
The maximum extension length is marked!
4.2.1. Horizontally adjustable leg
rests (optional)
These are attached, detached, swung away and adjusted as the
standard leg rests are.
Horizontal adjustment functions:
• push lever forwards
• put the leg rest into the desired position by raising or lowering the
foot plate bracket tube
• release lever; leg rest locks automatically
Make sure that both leg rests are adjusted
to equivalent height and that the adjusting
screws are tightened!
Bischoff & Bischoff GmbH | 13.02.2020
S-ECO 2
11
14