Backrest; Armrests; Side Parts; Control Unit - B+B Terra Mode D'emploi

TERRA/TERRA SX
| Electric Wheelchair
Seat angle
• The initial setting of the seat angle is 1° backward.
• The seat angle can be set from -2° to +10° in steps of 3°.
• Release the front seat fastener (fig. 05).
• Take out the screws and adjust the seat to the desired angle.
• Place the screws into the nearest hole, then tighten them
05 • again.

3.5.3. Backrest

The angle of the backrest of your electric wheelchair has a manual
recline function and can be easily adjusted to the wanted position by
pulling the strap at the lower end of the backrest. You also have the
option of folding the backrest completely down to the front.
• You can adjust the angle of the backrest from 90° to 120° in four
steps.
06
• Pull the cable behind the back while holding the backrest with the
other hand (fig. 06).
• After letting go of the cable the bolts will lock into place.

3.5.4. Armrests

The armrests can be completely taken off, to be able to get in and out
of the chair from the side. In addition, the height of the armrests can
42
Always be sure to use self-locking nuts to secure the
attachment.
Make sure that both bolts on the left and right are
completely locked in place.
Electric Wheelchair |
be adjusted. They can also be adjusted sideways by adjusting the side
parts (see side parts).
Removing the armrests
• To remove the armrest, loosen the wing bolt and pull out the
armrest to the top (fig. 07).
• When installing the armrest, make sure it is inserted all the way
and fastened again.
Adjusting the height
• First take the armrest out of the mounting.
• Remove the arresting bolt and screw it back into the armrest at the
desired position (fig. 08).
• The lowest hole represents the maximum height of the

3.5.5. Side parts

You can move the side parts sideways.
• Loosen the fastening screw underneath the seat and move the side
part into the desired position (fig. 09).
• Tighten the screw again.
Make sure the fastening is firmly tightened.

3.5.6. Control unit

The control unit can be mounted either on the right or lefthand side
underneath the armrest in each case. In addition, the distance can be
adapted to the lower arm length.
• Unscrew the toggle screw below the armrest and adjust to the
required length (fig. 10).
• Tighten the toggle screw again.
Bischoff & Bischoff GmbH |01.06.2019
TERRA/TERRA SX
07
armrest.
08
09
10
43