Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
Indicator Light
(LED Window)
Indicator Light (LED window)
The indicator light (LED Window) will flash 1
second when the dogtra YS300 has been turned on.
Then after 2 seconds, it will flash every 2 seconds. If
the dog does not bark over 10 seconds, it will turn to
the Sleep mode to save battery life and the LED will
turn off.
Before going into Sleep mode, the LED light flashes
green when the battery is fully charged and turns to
amber when the battery life is getting low. When the
LED indicator emits a blinking red light, the battery
needs to be recharged.
Battery life
Fully charged
LED window
On Working
Flashes Green
On Charging
Stays on Green
34
Medium charge
Needs charge
Flashes Amber
Flashes Red
Stays on Red
Stays on Red
Contact Points
YS300 uses Surgical Stainless Steel contact points
to protect the dog's skin.
The length of the contact points should be well-
fitted so that the contact points are held firmly
against the dog's skin.
IMPORTANT : Avoid touching the Contact points
unless the Anti-Bark Collar is completely
discharged, or you may feel the electrical
stimulation your self.
Plastic Dummy Contact Points
If your dog is trained enough, you can replace the
Contact Points with the Plastic Contact Points
included in the package. By doing so, it will allow
you to keep the collar on your dog for a longer
period of time with less irritation on the skin. You
may also use the Pager mode as a useful tool in
correcting your dog without the stimulation,
however, only leave the collar on for 8-hour at a
time if the stainless steel contact points are still
being utilized.
DESCRIPTION
35
Publicité
Table des Matières
