Toilet Operation; Freshwater Flush (With Dfs-2F Switch); Freshwater Flush (Toilet With Dfst Switch) - Dometic MASTERFLUSH MF7100 Instructions De Montage Et De Service

Macerator Toilet

5 Toilet Operation


CAUTION
Do not operate toilet without water supply turned
on. Damage to internal components may occur.
5 .1 Freshwater Flush (with DFS-2F
switch)
5
5 .1 .1 Toilet system start-up
1. Turn on fresh water supply to toilet.
2. Press "Flush" switch (2) and hold for at least 10
seconds.
3. Toss several sheets of toilet paper into bowl and
repeat cycle. The bowl should completely clear.
5 .1 .2 Normal flushing
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) until desired water level is
achieved. (Do not press "Add Water" switch too long or
overflow may occur.) More water is usually added only
when flushing solids.
EN
q
w
FLUSHING TOILET
Press "Flush" switch (2) down and hold until waste
drains from toilet bowl (about 10-20 seconds). This
switch activates a macerator pump that siphons water
and waste from the bowl, macerates, and propels the
effluent to the discharge line/holding tank.
To use less water for liquid-only flushes, press "Flush"
switch for shorter period of time.
5 .2 Freshwater Flush (toilet with
DFST switch)
w
6
5 .2 .1 Toilet system start-up
1. Turn on fresh water supply to toilet.
2. Press "Flush" switch (2) and hold for at least 10
seconds.
3. Toss several sheets of toilet paper into bowl and
repeat cycle. The bowl should completely clear.
5 .2 .2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) and hold until desired water
level is achieved. (Do not press "Add Water" switch too
long or overflow may occur.)
Toilet Operation
q
e
7