Checking The Built-In Battery; Operating The Blower; After Finishing Work; Transporting - Stihl BGA 45 Notice D'emploi

Masquer les pouces Voir aussi pour BGA 45:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

English
► If the trigger, trigger lockout or release slide is
stiff or does not spring back to the idle posi‐
tion: Do not use the blower and contact your
STIHL servicing dealer.
The trigger, trigger lockout or release slide has
a malfunction.
Switching On
► Insert the activation key.
► Push the release slide in the direction of the
blower tube with your thumb and hold it there.
► Depress the trigger lockout and hold it in that
position.
► Pull the trigger and hold it there.
Air flows from the nozzle.
► If 3 LEDs flash red: Remove the activation key
and contact your STIHL servicing dealer.
Malfunction in blower.
► Release the trigger.
No air flows from the nozzle.
► If air continues to flow from nozzle: Remove
the activation key and contact your STIHL
servicing dealer.
Blower has a malfunction.
10.2

Checking the Built-In Battery

► Press the button.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the blower and contact your STIHL servicing
dealer.
There is a malfunction in the built-in battery.

11 Operating the Blower

11.1
Holding and Controlling the
Blower
► Hold and control the blower with one hand on
the control handle - wrap your thumb around
the handle.
24
11.2
Blow-Sweeping
► Point the nozzle at the ground.
► Walk slowly and steadily forwards.

12 After Finishing Work

12.1
After Finishing Work
► Switch off the blower and remove the activa‐
tion key.
► Clean the blower.

13 Transporting

13.1

Transporting the blower

► Switch off the blower and remove the activa‐
tion key.
Carrying the blower
► Carry blower by the control handle in one
hand.
Transporting the blower in a vehicle
► Secure the blower so that it cannot topple over
and cannot move.
► If the blower need to be packed: Observe the
following points when packing the blower:
– Packaging or transport box must be non-
conductive.
– Make sure the blower cannot shift inside the
packaging or transport box.
– Secure the packaging or transport box in
such a way that the packaging or transport
box cannot move.
Owing to the built-in battery, the blower is sub‐
ject to the requirements for transporting dan‐
gerous goods. The blower is classified as UN
3481 (lithium-ion batteries in equipment) and
has been tested pursuant to UN Manual Tests
and Criteria Part III, Subsection 38.3.
The transport regulations can be found in
www.stihl.com/safety-data-sheets.
11 Operating the Blower
0458-719-9621-B

Publicité

Table des Matières

Dépannage

loading

Table des Matières