Preparing The Blower For Operation; Charging The Blower, Leds; State Of Charge - Stihl BGA 45 Notice D'emploi

English
► If the blower or the charging cable require
servicing or repairs: Contact your STIHL
servicing dealer for assistance.
5 Preparing the Blower for
Operation
5.1 Preparing the Blower for Oper‐
ation
The following steps must be performed before
commencing work:
► Ensure that the following components are in
safe condition:
– Blower, 4.7.1.
– Charging cable,
► Check the built-in battery,
► Fully charge the blower,
► Clean blower,
15.1.
► Mount the blower tube and nozzle,
► Check the controls,
► If it is not possible to carry out these steps, do
not use the blower. Consult a STIHL servicing
dealer.
6

Charging the Blower, LEDs

6.1 Charging the Blower
The charging time depends on several factors,
e.g. temperature of the blower or ambient tem‐
perature. The actual charging time may differ
from the specified charging time. For specified
charging times see www.stihl.com/charging-
times.
The charging process starts
automatically when the plug is
inserted in a wall outlet and the
charging cable is connected to
the blower. The charging proc‐
ess stops automatically when
the blower is fully charged.
The blower and charging cable heat up during
the charging process.
► Remove the activation key.
22
4.7.2.
10.2.
6.
7.
10.

5 Preparing the Blower for Operation

1
2
3 3
4
► Insert the plug (2) in a convenient wall outlet
(1).
WARNING
■ Persons may trip over the connecting cable.
This can result in injuries and may damage the
charging cable.
► Lay the connecting cable flat on the floor.
► Position the connecting cable (3).
► Insert the charger plug (4) in the charge
socket (5).
The LEDs (6) glow green and show the state
of charge.
► If the LEDs (6) stop glowing: Disconnect the
charger plug (4) from the charge socket (5).
The blower is fully charged.
► Disconnect the plug (2) from the wall outlet
(1).
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green:
Recharge the blower.
6.3 LEDs
The LEDs can indicate the state of charge or
malfunctions in the blower. The LEDs can glow
or flash green or red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
17.
Malfunction in blower.
6
5
80-100%
60-80%
40-60%
20-40%
0-20%
0458-719-9621-B