Lenze EPM-H502 Instructions De Mise En Service page 73

5.3 Status messages of the operating unit
The operating unit status can be queried any time. Information can be obtained
about
the interface (Port)
ƒ
the name of the loaded driver (Driver)
ƒ
the version of the loaded driver (Ver)
ƒ
the network address of the operating unit (Addr)
ƒ
the last error (Error)
ƒ
You want to ...
A query the status of the operating unit.
1. Briefly touch the display in one of the
corners 0, 1, 2 or 3.
– Note: This corner must not contain
a selectable field.
2. Immediately touch the diagonally
opposite corner for a moment.
B switch between the status displays of
different ports.
E.g. between CAN port and ASP port
l
l Status messages are only displayed
for assigned/used ports
C close the status display.
EDBPM−H502 DE/EN/FR 5.1
Status messages of the operating unit
Touch the fields ...
ESC
l
Commissioning
Example
0
3
Port : NET
Driver : CAN Lenze M
Ver : X.XX
Addr : NO ADDRESS
Error : RESET
Port : NET
Driver : CAN Lenze M
Ver : X.XX
Addr : NO ADDRESS
Error : RESET
5
1
2
PROG
TRANS
PAGE
ESC
PROG
TRANS
PAGE
ESC
73