Recommended Grip - Panasonic EY7206 Instructions D'utilisation

EY7206取説(USA) 07.3.27 19:55 ページ 6
B428077_EY7206_USA_Tori
(A)
(B)
(C)
(D)
(E)
(F)
(J)
(K)
(A) Nose protector
(B) 6.35 mm(1/4") hex quick connect chuck
(C) LED light
(D) Variable speed control trigger
(E) Impact mode selector switch
(F) Bit holder
(inside of the body)
(G) Forward/Reverse lever
(H) Belt hook lock lever
( I ) Belt hook
(J) Battery pack release button
(K) Battery pack (EY9201)
(L) Battery charger (EY0110)
Refine_EY7206_USA.6.p1.pdf
Refine_07-03-27 19:59:10
(L)
(G)
(H)
( I )
– 6 –
EY7206取説(USA) 2007.03.29 12:45 ページ 7
4 07-03-29 15:56:30
Maximum torque
Impact mode
Maximum R.P.M.
S: 80 N·m, (820kgf-cm, 711in-lbs)
soft impact mode 0 - 1800 min (rpm)
-1
H: 120 N·m, (1220kgf-cm,1060in-lbs)
hard impact mode 0 - 2600 min (rpm)
-1
Refine_EY7206_USA.7.p1.pdf
Refine_07-03-29 12:53:55

Recommended Grip

Use the grip to hold and operate the driver
with one hand. If the job requires additional
force, you can push against the rear end of
the driver with your other hand.
Select the impact mode
This unit is equipped with impact mode
selector switch. By sliding the mode selec-
tor switch, soft impact mode or hard impact
mode can be selected.
NOTE:
Make sure that the switch is not
pulled out when carrying out this
procedure.
Soft impact mode has lower torque setting
and help avoiding the damage of material
caused by over-tightening power. It is
recommended to select this mode to
minimize the damage of small size screw
head or the damage of the soft material
surface to be fastened by controlling the
trigger switch.
Hard impact mode has maximum torque
and rotation speed setting.
When you set the impact mode, make sure
to slide the mode selector switch fully to
the desired impact mode setting.
Do not slide the switch before the rotation
has completely stopped.
S H
S H
S : Soft impact mode
H : Hard impact mode
Recommended application
small size screw,
soft material, thin metal stud
long size screw
bolts/nut
– 7 –