Displays And Pushbuttons; Functions - Becker Centronic SunWindControl SWC442 Notice D'utilisation

Operating Instructions

Displays and pushbuttons

MAN/AUTO Sliding Switch
When the sliding switch is set to
DOWN pushbutton commands) are executed and an alarm signal (e.g.: wind
alarm if wind sensor is integrated) given.
When the sliding switch is set to
(e.g. sun protection function, ...).
Transmission control light
A radio signal is indicated by the transmission control light being lit. If the battery
starts running out, the transmission control light fl ashes during transmission.
The transmitter power and/or radio range is reduced when the battery is run-
ning low. If the transmission control light is no longer lit when the pushbutton is
pressed, the batteries must be changed.
16
Sliding Switch
RETRACT button
STOP pushbutton
EXTEND button
Battery compartment
Setting aid
Wind threshold control switch
Sun threshold control switch
Programming pushbutton
Light controller push button
Transmission control light

Functions

, manual control commands (e.g.: UP, STOP,
, automatic control commands are executed