Becker Centronic SunWindControl SWC442 Notice D'utilisation page 17

Group
Group control means controlling one or several receivers at the same time. The
programmed group is activated using a single command.
Wind threshold control switch
This control switch allows you to set the wind threshold values (approx. 2m/s
to 22 m/s).
The wind threshold value can be set to 11 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: retract when wind speed is low
+ Right limit stop = Level 11: retract when wind speed is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value.
If the wind speed rises above the preset wind threshold, the sun protec-
tion system is retracted and remains closed. The sun protection sys-
tem is extended again if the wind speed remains below the preset wind
threshold for approx. 15 minutes.
Sun threshold control switch
This control switch allows you to set the sun threshold values (approx. 5KLux
to 50KLux).
The sun threshold value can be set to 15 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: extend when sun intensity is low
+ Right limit stop = Level 15: extend when sun intensity is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value.
If the sun intensity rises above the preset sun threshold, the sun pro-
tection system is extended after approximately 1.5 minutes. The sun
protection system is retracted again automatically if the sun intensity
remains below the sun threshold for approx. 15 minutes.
DE
GB
FR
NL
17