Control Elements And Connections; Technical Data - Abicor Binzel xFUME ADVANCED Mode D'emploi

4 Product description

4.2 Control elements and connections

Fig. 3
A On/Off switch
B Auto/Manual switch
C Fuse
D Power LED
E Service LED
I
H
G
Auto/Manual switch (B)
Power LED (green) (D)
Service LED (orange) (E)

4.3 Technical data

Tab. 1
Connection voltage
Rated frequency
Drive power
Filter surface
Connection diameter
Max. air volume flow*
Sound pressure level LpA
Max. inlet air pressure
Fuse on mains side
Weight
Dimensions (L × W × H)
* 1 extraction hose connection length 5 m connected, second connection closed.
► Obtain the volume flow to be provided at the connector to achieve the actual induced speed according
to DIN EN ISO 21904 V
From June 2021
EN - 10
Control elements/ports
C
A B
The automatic starting function is activated when the switch is set to
Auto. If the switch is set to Manual, the automatic starting function is
inactive and the device must be switched on and off manually.
The power LED illuminates green continuously when the motor is
running. During initialization, the power LED and the service LED flash
alternately.
The device is equipped with a safety device to monitor the minimum air
volume flow to be extracted. A differential pressure switch is used for
monitoring purposes. The service LED illuminates in orange continuously
when both filter cartridges are not functioning properly or are saturated
and must be replaced. During initialization, the service LED and the
power LED flash alternately.
General information
from the operating instructions of the corresponding fume extraction torch.
i
xFUME
F Current clamp port
G Output regulator
H Hour meter
I Mains connecting cable
D
E
F
115 V
50 Hz/60 Hz
2 × 0.8 kW
2 × 0.8 m²
60 mm
260 m³/h
< 72 dB (A)
5–6 bar
16 A
40 kg
370 mm × 370 mm × 900 mm
®
ADVANCED
230 V