Videotec ULISSE MAXI Manuel D'instructions page 49

Connect the lines according to the instructions in the
following table.
RS485 SERIAL LINE CONNECTION
RS485 Colour
RS485 A (+) Grey
RS485 B (-) Pink
Tab. 14
The RS485 male connector is supplied
with the standard equipment kit of the
Ulisse unit; if not available, you need to
cut the female connector to connect to the
telemetry cables.
Open the window of the dip-switches to access the
hardware configuration (Fig. 98, page 47).
Fig. 98
Enable SW1 on the first dip-switch (DIP1) to obtain
the INFO panel on the Video output (Fig. 99, page 47).
When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
DIP1
Fig. 99
MNVCUPTMAXIR_2104_EN
If in the INFO panel "i3" is displayed, it means the
Ulisse unit is working in ONVIF mode (Fig. 100, page
47).
INFO INFO
------------------------ ------------------------
Device ID : 00001 Device ID : 00001
Type Type : Rs485 Tx-Rx : Rs485 Tx-Rx
Baud Rate : 38400-8N1 Baud Rate : 38400-8N1
Protocol Protocol : MACRO : MACRO
Net Board : Ver 6.0.0 Net Board : Ver 6.0.0
Mpp Board : Ver 6.0.0 Mpp Board : Ver 6.0.0
: Net1 Mpp0 i3
Hardware Hardware : Net1 Mpp0
P.C. P.C. : UPT1SVWAN00E : UPT1SVWAN00E
S.N. S.N. : 113070530001 : 113070530001
Upgrade Upgrade : NET BOARD : NET BOARD
Fig. 100
Enable SW6 of the second dip-switch (DIP2) to enable
RS485 mode (Fig. 101, page 47).
When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
DIP2
Fig. 101
i3
47