Videotec ULISSE MAXI Manuel D'instructions page 29

8.10 Desiccant bag
Insert the desiccant bags (01) in the position
indicated in the illustration, after having taken them
out from the transparent packaging and folding them
in half. Fasten the sachets by means of the plates (02)
and screws supplied (03).
Fig. 45
MNVCUPTMAXIR_2104_EN
03
02
01
8.11 LED illuminator activation
and adjustment instructions
Once the adjustment is done the illuminator on
the left (MASTER) synchronizes and controls the
illuminator on the right (SLAVE).
The dusk switch detects the room light and controls
the activation and deactivation of the illuminators
when brightness reaches the level set by the user.
When the LED illuminators are active the camera
goes to night mode with the special ONVIF control.
8.11.1 Description of the LED
illuminator
Do not remove the transparent screw of the
twilight sensor in order not to affect the
security and operation of the illuminator.
• Twilight sensor: Detects the light level.
• Cable: Power supply and control.
• Switch-on threshold regulator: The
potentiometer allows adjusting the sensitivity
threshold to switch on the illuminator.
• Infrared power control: The potentiometer allows
adjusting the power of the illuminator.
Twilight sensor
Switch-on threshold
regulator
Fig. 46
Cable
Infrared power control
27