Videotec ULISSE MAXI Manuel D'instructions page 33

8.13 Hardware configuration
Hardware configuration is only required
if you wish to activate communication via
serial telemetry (12.1 How to switch from
ONVIF communication mode to RS-485
(telemetry) mode, page 45).
8.13.1 Opening the configuration door
Before powering the device it must be configured
correctly by setting the dip-switches inside the
configuration window. Open the hatch by undoing
the screws as shown in figure.
Fig. 53
The DIP-switches appear as shown in the figure.
Fig. 54
After installation and wiring, close the
product again.
8.13.2 DIP1 configuration
When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
Switch 1 is used to update the firmware.
Fig. 55
MNVCUPTMAXIR_2104_EN
DIP1 CONFIGURATION
Description SW SW
4 3
Baud rate OFF OFF
adjustment
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
Firmware update – –
– –
Tab. 9
8.13.3 DIP2 configuration
When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
The Pan & Tilt can be controlled via various protocols.
Fig. 56
DIP2 CONFIGURATION
Protocol SW SW
8 7
PTZ Manager1 OFF OFF OFF OFF OFF OFF OFF OFF
MACRO OFF OFF OFF OFF OFF ON
(VIDEOTEC)
PANASONIC OFF OFF OFF ON
PELCO D OFF OFF OFF OFF ON
AMERICAN OFF OFF OFF OFF ON
DYNAMICS
VISTA OFF OFF OFF ON
Tab. 10 1 Deafult configuration: MACRO (VIDEOTEC), 115200
baud, Address 1. This option does not require the
setting of the DIP-switch (DIP1, DIP3).
SW SW Baud rate
2 1
OFF – 300 baud
OFF – 600 baud
OFF – 1200 baud
OFF – 2400 baud
ON – 4800 baud
ON – 9600 baud
ON – 19200 baud
ON – 38400 baud
– ON Set up enabled
– OFF Set up disabled
SW SW SW SW SW
6 5 4 3 2
ON
OFF ON OFF OFF
OFF OFF ON
ON ON
OFF OFF ON
SW
1
ON
OFF
ON
31