Videotec ULISSE MAXI Manuel D'instructions page 27

8.8 LED illuminators installation
To work properly both illuminators must be
installed together.
From Pan & Tilt, it is only possible to install
VIDEOTEC illuminators.
8.8.1 Counterweight removal
Undo the screws and remove the external
counterweights.
Fig. 37
8.8.2 Fitting the illuminator on the
bracket
Identify the front holes on the counter-weight
bracket.
Fig. 38
MNVCUPTMAXIR_2104_EN
Place the fixings of the illuminator (01) on those of
the bracket (02).
Fig. 39
Tighten the screws and the washers previously
removed.
Fig. 40
Pay attention to the fixing. Tightening
torque: 6Nm.
02
01
01
02
25