Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before using this machine, please carefully read though these HANDLING INSTRUCTIONS.
Ensure that you know how the machine works, and how it should be operated. Maintain the
machine in accordance with the instructions, and make certain that the machine work correctly,
please store this instriation and other enclosed documents with the machine together.
The following symbols are located on the machine, nameplate, and carton box:
It is important and imperative that the safety signs on the machine remain readable and understandable.
! Danger ! Ignoring warnings can cause serious injury or equipment damage.
Do not dispose of electric tools together with
household waste material.
Read and understand the instruction manual
before using the machine.
Wear eye protection.
Wear safety gloves.
Wear ear protection.
Danger, rotating blade: risks of cuts.
PROFILE OF THE MACHINE (with standard accessories)
1.
Base with rubber feet
2.
Bow safety clamp
3.
Vice
4.
Protective plate
5.
Tension quick release lever
6.
Main handle
7.
On/Off switch
Standard accessories:
- 1 Hex wrench 4mm
- 1 Wrench 13mm
- 1 Length stop
- 4 Rubber feet
- Voltage - Frequency: 230 V - 1~50 Hz - 5 A
- Motor power: 1500 W – 2 CV
- Cutting speed: 20~70 m/min
- Blade size (L x W x T): 1140 x 13 x 0,65 mm
- Vise clamping capacity: 105 mm
GB
SYMBOLS
Please read the following information carefully.
TECHNICAL SPECIFICATIONS
19
Machine nameplate
Blade cutting direction.
Wear dust mask.
Machine must be earth grounded.
8.
Cutting speed regulator
9.
Blade 1140x13x0.65mm
10.
Motor housing
11.
Carbon brush cap
12.
Length stop
13.
Cutting angle scale
Document:
- Instruction manual (original in English)
Publicité
Table des Matières
