Scope Of Delivery; Connecting The Appliance; Electrical Connection - Bosch B30IR800SP Notice D'utilisation Et De Montage

Masquer les pouces Voir aussi pour B30IR800SP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en-us

Scope of Delivery

After unpacking all parts, check for any damage
in transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
Customer Service department.
The following parts are included:
Built-in appliance
Interior fittings (depending on model)
Bag containing installation materials
Operating Instructions
Installation Instructions
Customer Service Booklet
Warranty enclosure
Information on the energy consumption and noises.

Connecting the Appliance

Have a technician install and connect the appliance
according to the enclosed Installation Instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
Apart from statutory national regulations, you should
comply with all applicable local electricity companies
codes and requirements.
After installing the appliance, wait at least 1 hour before
switching the appliance On. During transportation
the oil in the compressor may have flowed into
the refrigeration system.
Before switching the appliance On for the first time,
clean the interior of the appliance (see chapter
"Cleaning the Appliance").
6

Electrical Connection

,
WARNING:
Avoid the risk of an electric shock!
,
WARNING:
Insert into a grounded 3-wire receptacle. Never
remove grounding phase. Do not use any
adapters. Do not use any extension cords.
,
WARNING:
Non-compliance with these instructions may
result in death, fire or an electric shock.
Improper connection of the protective conductor
may result in an electric shock. If you are in
doubt whether the appliance has been grounded
properly, have the appliance tested by
a qualified electrician or service technician.
The receptacle must be installed according to the
Installation Manual.
The appliance complies with protection class I.
Connect the appliance to 115 V/60 Hz AC through
a correctly installed 3-wire grounded receptacle.
The receptacle must be protected with a 10 to 16 A
fuse.
The appliance comes with a UL registered 3-wire
Power Cord.
Do not use extensions or distributors.
Please see the following table:
Appliance
Maximum Simultaneous Load
Refrigerator 30"
2.0 amps
Check on the Rating Plate whether the indicated
voltage and current type correspond with the values of
your power supply. The location of the Rating Plate
can be found in the chapter "Customer Service".
,
WARNING:
Never connect the appliance to electronic
energy saving devices.
Our appliances can be used with power line and
sine-controlled inverters. Power line-controlled
inverters are used for photovoltaic systems
which are connected directly to the national grid.
Sine-controlled inverters must be used for
isolated applications (e.g. on ships or
in mountain lodges) which are not connected
directly to the national grid.

Publicité

Table des Matières
loading

Table des Matières