ENAR CRENA 22 Manuel D'instructions page 166

4. If the machine is equipped with electric start, follow points 1 and 3, then turn the key in the ignition (1) to
"START" position. After starting the engine with the key back to "ON" and for running the engine remains in
this position.
Always observe instructions and principles described in the operation manual for the HONDA
engine.
5. Set up the throttle lever (1) into the "idle speed" position (turtle).
en
NOTE!!! Throttle lever (1) is to be set up only in two positions - "Idle speed" (turtle) or "Full speed"
(hare). Never set the throttle lever into intermediate positions, as that may lead to serious damage of
the centrifugal clutch
6. Pull the grip of the recoil starter slightly until resistance is felt, then pull vehemently. The engine would start
up. Do not release the recoil rope, hold it and return it slowly into the original position.
7. Let the engine to warm up, and then return the choke lever back into the "OFF" position.
8. Let the engine to idle for a while to allow it to warm up before it is loaded.
REVERSIBLE VIBRATORY PLATE COMPACTOR
CRENA 52*, 63*
20