GIESSE RACK MAX 650 Manuel D'utilisation Et D'installation page 50

Communication error
communication between the
2
devices has been interrupted, or
devices which have been R
separately are being used
3 Electromechanical lock error
Internal setting discrepancy:
4
There is a discrepancy in the
internal setting of the actuators.
R procedure error:
ESET
the R procedure has not been
ESET
5
completed correctly or has been
interrupted
Wiring error:
the power supply cables of devices
6
configured in synchronized mode
have been reversed
Encoder error:
7
count error in the internal encoder
Electrical power supply error:
8
the power supply voltage is outside
the permitted range or is not stable
Alignment error:
the difference in position of the
9
actuators rack connected in
synchronized mode exceeds the
maximum permitted
Memory error:
10
saving of data to the internal
memory has failed
Connection error:
a R procedure is being started
ESET
11
with several actuators other than
synchronizable models
LED state
STEADY ON
FLASHING
ESET
WITH GREEN LED
Device receiving power correctly
The device has performed a retraction stroke correctly and completed
the operation by saving the data in the memory, or is in motion.
Device receiving power correctly The device has performed an
extension stroke correctly. The number of flashes indicates the number
assigned to the device previously, during the R
Check the state of the connection cables and
repeat the R
ESET
Check the electromechanical lock. Check the
related manual
Repeat the R
ESET
Repeat the R
ESET
Check and correct the wiring
Repeat the R
ESET
Check the electrical contacts at the ends of the
actuator cable and that the power supply
voltage is correct
Repeat the R
ESET
Repeat the R
ESET
Check the type of actuators chosen for the
system then repeat the R
Meaning
50
procedure if necessary
procedure
procedure
procedure
procedure
procedure
procedure
ESET
procedure
ESET