Electrical Connection - GIESSE RACK MAX 650 Manuel D'utilisation Et D'installation

11. ELECTRICAL CONNECTION

Devices are equipped with cables constructed in compliance with current safety standards
and restrictions for protection against radio interference.
E
VERY MODEL OF ACTUATOR MUST BE EQUIPPED WITH ITS OWN SPECIFIC CABLE
Before making the electrical connection, check using the table below that the
power supply cable is correct for the voltage data provided on the label affixed
to the actuator.
Power supply voltage
110-230V~ 50/60Hz
24V
If the power supply cable has to be extended to reach the control push-button for low voltage
(24V ) actuators, cables of the correct cross-section must be used. The wire cross-
sections are specified in the table on page 9 (Power supply cable cross-sections).
Number of
Cable length
wires
2 m
2 m
Power supply wires
B
LUE
3 B
LACK
B
ROWN
R
ED
3
B
LACK
45
.
Communication
wires
-
G
REEN