Installation Steps; Care And Cleaning - AVS Bugflector Instructions D'installation

Installation Steps

Center hood shield and attach with ex-
posed tape. Remove tape liner.
Bump On
3/4" (1.9 cm)
washer
screw
3
NOTE: The hood shield should be offset approxi-
mately 3/4" (1.9 cm) from the front edge of hood.
Optional Screw Attachment
Hood Hood shield Washer
91-94 Chevrolet Cavalier uses no screws
5
96-up Dodge Caravan/Plymouth Voyager uses
(2) screws only

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from drawings.
or
Bump On
washer
screw
Do No Overtigthen
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2006 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo, Chromeflector
TM TM
Apply pressure to tape flange.
NOTE: If applicable position hood shield over trim.
92-99 Ford Fullsize Van - under trim
4 91-96 Ford Escort - discard rubber trim
99-up F250/350 - discard rubber trim
Lower hood, adjust hood bumper stops if
necessary. Apply bump-ons to hood surface.
6
, and the AVS logo are trademarks of Lund International, Inc.
TM TM
Page 2 of 2