Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Electrical installation
Wiring according to EMC
6
Electrical installation
Wiring according to EMC
For wiring according to EMC requirements observe the following points:
)
Note!
Separate control cables/data lines from motor cables.
ƒ
Connect the shields of control cables/data lines at both ends in the case of
ƒ
digital signals.
Use an equalizing conductor with a cross−section of at least 16 mm
ƒ
(reference: PE) to avoid potential differences between the bus nodes.
Observe the other notes concerning EMC−compliant wiring given in the
ƒ
documentation for the standard device.
38
l
2
EDK2192IB DE / EN / FR 2.0
Publicité
Table des Matières
