Assembly & Operation - Worx WG116 Mode D'emploi

SYMBOLES
Warning
Read the manual
Wear eye protection
Wear ear protection
To avoid possibility of electric
shock, do not use in damp or wet
conditions
Keep all other people, including
10
children, pets and bystanders
outside the 15 meters hazard zone,
stop the trimmer immediately if you
are approached.
Before any work on the machine
itself, pull the power plug from the
outlet.
Double insulation
Trimming
Edging
4 AMP Electric Grass Trimmer/Edger EN
All manuals and user guides at all-guides.com
ASSEMBLY & OPERATION
Assembling The Main Handle See Fig. A
Assembling The Safety Guard See Fig. B
Assembling The Flower Guard See Fig. C
Assembling The Auxiliary
Handle
Attaching the extension cord
Trimming
Edging
Manually Feeding The Line
Replacing the Trimmer Line
And Spool
Manually Winding the Line
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a
small length of line is fed out.
A 'clattering' noise will be heard for a short
time. This is normal and is caused by the line
being cut by the line cutter. Once the line is
cut to the correct length, the 'clattering' noise
will stop and the trimmer motor will run at full
speed.
To feed more line, stop the trimmer
completely, then restart, allowing the motor to
reach full speed. Repeat this until you hear the
'clattering' noise of the line cutting.
2. MANUALLY WINDING THE LINE
(See Fig. L, M, N, O)
Take approximately 16ft (5m) line and insert
5/8" (15mm) of line into one of the holes in the
upper section of the spool (See Fig. L). Wind
the line in the direction of the arrows on the
top of the spool (See Fig. M).
Leave approximately 4" (100mm) of line
unwound and place it into the cleat. Repeat on
the lower section of spool.
Care should be taken to ensure that the line is
neatly coiled on the spool (See Fig. N). Failure
to do so will impair the efficiency of the
automatic line feed.
Action
See Fig. D
See Fig. E1, E2
See Fig. F
See Fig. G1, G2
See Fig. H
See Fig. I, J, K
See Fig. L, M,
N, O
Figure