Worx WG116 Mode D'emploi page 8

disconnect from receptacle. Keep cord
from heat, oil, and sharp edges.
l) Don't grasp the exposed cutting
blades or cutting edges when
picking up or holding the appliance.
m) Don't force appliance. It will do the job
better and with less risk of injury at the
rate for which it was designed.
n) Don't overreach. Keep proper footing
and balance at all times.
o) Stay alert. Watch what you are doing.
Use common sense. Do not operate
appliance when you are tired.
p) Disconnect appliance. Disconnect
the appliance from the power supply
when not in use, before servicing, when
changing accessories such as blades, and
the like.
q) Store idle appliances indoors. When
not in use, appliances should be stored
indoors in dry, and high or locked-up
place, out of reach of children.
r) Maintain appliance with care.
Keep cutting edge sharp and clean for
best performance and to reduce the
risk of injury. Follow instructions for
lubricating and changing accessories.
Inspect appliance cord periodically,
and if damaged, have it repaired by
an authorized service facility. Inspect
extension cords periodically and replace
if damaged. Keep handles dry, clean, and
free from oil and grease.
s) Check damaged parts. Before further
use of the appliance, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function. Check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
condition that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center unless
indicated elsewhere in this manual.
SAVE THESE INSTRUCTIONS
4 AMP Electric Grass Trimmer/Edger EN
All manuals and user guides at all-guides.com
Figure 1
Method of securing extension cord
ADDITIONAL SAFETY RULES
FOR LAWN TRIMMER AND
EDGE TRIMMER
1. Keep guards in place and in working order.
2. Do not use this product without the guard
3. Keep hands and feet away from cutting
4. Do not use heavier lines than
5. Do not use line materials of other types
SAVE THESE INSTRUCTIONS
Table 1
Minimum gauge for extension cords
Volts Total length of cord in feet
120V 25
240V 50
Ampere rating
more than not
more than
0-6 18
6-10 18
10-12 16
12-16 14
APPLIANCE CORD
CORD
SET
being fitted.
area.
recommended in this manual.
– for example, metal wire, rope, and the
like.
50 100 150
100 200 300
AWG
16 16 14
16 14 12
16 14 12
Not
12
recommended
(A) TIE CORD AS
SHOWN
(B) CONNECT PLUG
AND RECEPTACLE
9