Sanitization Does Not Start - Jacuzzi muse Utilisation & Entretien

Sanitization does not start

In addition to the faults listed in the
"hydromassage does not start", sec-
tion, refer to the below described
The Sanitization cycle
stops of its own accord
lack of electric energy
command not accepted
insufficient water level
L1
lack of electric energy
insufficient water level
L1
level sensor fault (the drainage
L2
valve is not activated)
failed communication between the
J.touch remote control and the on-
board computer
47
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- follow the instructions provided in the rela-
tive chapter
- add water until it covers the nozzles on the
backrest (refer also to the Chapter "Sanitization")
and press the key once again
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- add water within about 5 minutes from the
appearance of the warning (the function will
resume automatically); where this is not the
case, the function will be definitively reset
- contact an authorized Jacuzzi® service centre.
- wait a few seconds until the connection is es-
tablished;
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician);
- try switching off and then on again the tub
and wait a few seconds until the connection is
established;
- once the tub is on and you have waited a
few seconds, try and press the "-" key until the
function keys light up;
- if this does not work, contact an authorized
Jacuzzi® service centre