Shiatsu - Jacuzzi muse Utilisation & Entretien

Shiatsu

(relax/tonic)
programme
activation
If the remote control
fails to activate or where the smallest
LED light flashes, the battery must be
charged (refer to the Chapter.
ing the J.touch remote control")
Once on, the J.touch remote control,
where not used, switches off after
about 15 seconds; to turn it on again,
lightly shake it
The "relax" and "tonic" programmes
are activated at preset intensity levels:
- relax: medium intensity (2 LED lights on)
- tonic: minimum intensity (1 LED light on)
To change programmes, simply press
the relative key (you must wait a few
seconds before the start-up)
varying the
hydromassage intensity
It is possible to adjust the intensity ac-
cording to ten levels, divided as follows:
0 - 2
3 - 5
6 - 9
The Shiatsu hydromassage operates in two modes:
- relax (relaxation) with a top to bottom sequence;
- tonic (tone up) with a bottom to top sequence.
Fill the tub, turn on the main switch and hold down the key displayed until the function keys
come on (the battery charge level and value - indicative of the water temperature - are also
briefly presented).
"Charg-
Hold down the "relax" or "tonic" keys (respectively, relaxing or toning massage): the
key will flash, indicating that the start-up procedure is underway.
When the flashing stops and the light becomes brighter, the function starts.
tonic
relax
The intensity progressively increases automatically, however it can be adjusted as de-
sired by holding down the "+" or "–" key (the LED light will flash briefly); in any case, after a
certain time, the intensity will vary based upon the characteristic trend of the programme
selected.
34
T
he Shiatsu hydromassage works thanks to a series of
microjets positioned along the "vu" meridian which ac-
cording to Chinese medicine provides energy from the back
to the entire body; the microjets are positioned so that they
make contact and activate all the cervical, dorsal and lum-
bar points.
35
35
35
35
35