Setting The Temperature; How To Fill The Water Tank; Dry Ironing - ottimo CEA-10-01 Manuel D'instructions

ENGLISH

SETTING THE TEMPERATURE

1. Always check garment labels for ironing instructions before ironing a garment.
2. If you do not have the ironing instructions at hand, the table below may help you.
3. Sort laundry before ironing: wool with wool, cotton with cotton etc. Start ironing the fabrics requiring
the lowest temperature and then progress to those requiring a higher temperature as it takes more
time for the iron to cool down than to heat up.
4. If the fabric consists of various kinds of fibres (e.g. cotton with polyester) you must always select the
ironing temperature for the fabric with the lowest recommended temperature.
5. Pure wool garments (100% wool) should preferably be ironed with the iron on the steam setting.
Select a high steam setting and use a dry ironing cloth.
6. Turn the temperature control to the desired temperature setting.
7. The desired temperature has been reached when the indicator light has gone off. The indicator light
will turn on and off from time to time, indicating that the selected temperature is being maintained.
LABEL FABRIC
Do not iron this article
Synthetic (nylon, acrylic, rayon, polyester)
Wool, silk
Cotton, linen

HOW TO FILL THE WATER TANK

1. Unplug your iron before filling the tank with water.
2. Set the steam control button to 0.
3. Fill water through the inlet to the MAX level of the water tank with the jug.
If the water in your area is particularly hard, it is advisable to use distilled or demineralized water
4.
5. Do not use chemically descaled water or any other liquids to refill the water tank.
6. Unplug the iron after ironing and allow it to cool. Turn the iron upside down and allow the water to
drain out.

DRY IRONING

1. Plug into the power point.
Turn the temperature control in a clockwise direction, selecting ● (1 dot), ●● (2 dots) or ●●● (3 dots)
2.
according to the heat requirement indicated on the garment label.
3. Once the indicator light goes on, stand the iron on a smooth and stable surface.
4. Once the required temperature has been reached, the indicator light will go off and the iron is ready
for use.
All manuals and user guides at all-guides.com
4
.